How Do Record Props Work? Just Like This…

It’s easy to get set up to display in a few minutes. Check out the How To video here for a quick peek into how Record Props work.

And when you’re ready, scroll on down for more details on how it works and how to begin setting up the wall mount installation.

It’s pretty straightforward to install, but you can contact us anytime for more support.

One Record Prop Provides two methods to display vinyl records.

TABLE TOP

The tabletop display option is easy like Sunday morning.

STEP 1: Take apart your Record Prop and place the Large X face up on a flat surface with the flat side down and the groove facing upward.

STEP 2: Grab an album and place it inside the groove.

STEP 3: ...Done! Sit back and enjoy.

wall mount

The wall mount display option takes under 10 minutes to install with just one screw (hardware included).

STEP 1: Find the perfect place on the wall. Drill a small hole to see if you hit a stud – if so, you can skip the drywall anchor. If not, insert the included drywall anchor and line up the Small X Mount over the hole, flush against the wall. (for exact drill hole measurements, head to our detailed install page)

STEP 2: Prepare the included screw and washer, then screw tightly to the wall.

STEP 3: Place the Large X over the Small X Mount, then insert the Pin Lock through the keyhole and twist.

STEP 4: Grab an album, slide the cover down against the wall, then carefully mount the vinyl record on the Pin Lock.

For tighter fits, turn clockwise as you push the center label toward the wall.

STEP 5: ...Done! Sit back and enjoy.

CHANGING Vinyl RECORDS

Grab your vinyl record at the edges and turn clockwise as you gently pull outward, toward yourself until it "pops" off.

Switch the Large X to change between single album sleeves and thicker double LPs or gatefolds. Unlock the center pin, then rotate 180 degrees and reattach.