HOW DO YOU DISPLAY YOUR VINYL?
Get Creative With Endless Combinations...
There are two primary ways to prop your albums:
The tabletop display is easy like Sunday morning.
STEP 1: Take apart your Record Prop and place the Large X face up on a flat surface with the flat side down and the groove facing upward.
STEP 2: Grab an album and place it inside the groove.
STEP 3: ...Done! Sit back and enjoy.
The wall mount display takes under 10 minutes to install.
STEP 1: Find a place on the wall that you'd like to mount your albums. Drill a small hole with a 7/8" bit and if needed, insert the drywall anchor into the wall.
Tip: Consider the placement on the wall. Your screw will be located at the exact center of the vinyl record you are displaying.
STEP 2: Take the Small X Mount and line it up over the hole / drywall anchor with the open side of the keyhole facing outward toward you, and the flat side against the wall...
STEP 3: Prepare your screw with the washer on, insert the screw and washer combo through the Small X Mount and into your pre-drilled hole / anchor...
STEP 4: Use a screwdriver to tighten until the Small X Mount is completely secured to the wall. The Small X Mount should be flush and tight, unable to easily move or rotate...
STEP 5: Place the Large X over the Small X Mount, then insert the Pin Lock through the keyhole and twist clockwise until the Large X is held securely to the wall.
STEP 6: Grab an album, slide the cover down against the wall, behind the Large X and then carefully mount the vinyl record on the Pin Lock, and lock into place by pushing on the center of your album (label) until it "pops" over the protective bumper.
STEP 7: Adjust for straightness... and Voilà! Sit back and enjoy.
CHANGING Vinyl RECORDS
Removing Your Vinyl: Changing records is quick and easy. Grab your vinyl record at the edges and turn clockwise as you gently pull outward, toward yourself. It will "pop" off, ready to play or store away.
Switch Sides: You can easily switch the Large X to change between single album sleeves and thicker double LPs or gatefolds. Twist the center Pin Lock counter-clockwise to release the Large X and then rotate 180 degrees and reattach.